Run an 8 oz hot water cycle into a measuring cup.Insert the paper clip in each and move it around to clean. Open the handle and look underneath to see the top entrance and exit needles.Rinse the pod holder with water and set it aside. Insert the straight end of the needle and then move it around in a circle a few times.Push the lever to show the exit needle, then hold it down while flipping the holder over. Press the button on both sides to separate the holder from the housing.Grab the sides of the pod holder and remove it from the brewer by gently pulling away.Turn off the brewer and unplug it and remove the water reservoir.As a result, the ground coffee build up starts to block the water flow inside your Keurig, potentially resulting in the Keurig not brewing a full cup of coffee. This is especially likely to happen if you don’t discard your pods soon after brewing. The coffee grounds can get stuck around the needle and eventually become dry and hard. This allows hot water to pass through the capsule. When you brew a K-cup, there are needles inside your coffee maker that make two holes in the pod.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |